Ignition, anti-theft alarm
| Ignition, anti-theft alarm |
| Ignition |
The ignition switch is connected to the control module (pin 10) so that the control module will be able to detect the voltage (+12 V) when the ignition is turned "ON" (+15). The alarm will be set off if it is armed, i.e. when a start attempt is made, the alarm and the "3-circuit break" (blocking of operating current to starter and fuel pump relays and +15 to the engine management system) will both be tripped.
| Important | ||
|
Observe the following: |
||
| • |
The anti-theft alarm cannot be armed if the ignition is "ON" (+15).
|
|
| • |
The anti-theft alarm will automatically disarm if the ignition is turned "ON" (+15) during the alarm delay period.
|
|
This project is supported by memberships and donations. If you use this site, please consider Joining SCNA and/or making a donation.
Our Friends
