Valve housing
Valve housing |
1. |
6-cyl:
Remove the engine covers.
|
2. |
Remove the transmission's breather hose.
|
3. |
Hook the lifting beam on the engine and raise the car.
|
4. |
Remove the air shields.
|
5. |
Remove the engine pad retaining bolts.
|
6. |
Remove the ground cable and engine mounting bracket retaining bolts.
|
7. |
Place an oil pan under the gearbox and remove the cooler hoses. Plug the holes and bend the hoses aside.
|
8. |
Remove the bolt securing the temperature sensor's cover (and also the valve housing cover).
|
9. |
Remove the remaining 8 bolts.
|
10. |
Lift up the valve housing cover and turn it to the right of the engine mounting. Use a rubber mallet to knock the cover loose.
|
12. |
Carefully remove the manual valve from the selector lever out of the retaining eye and carefully lift out the valve housing.
Note
|
To fit |
1. |
Thoroughly clean the sealing surfaces on the valve housing cover and transmission, leaving no residue of old sealing compound.
|
2. |
Lift the valve housing into position.
Note
|
3. |
Fit the nine valve housing retaining bolts and tighten them.
Tightening torque: 7 Nm (5 lbf ft). Note
|
4. |
Apply a bead of sealing compound to the transmission's sealing surface.
Note
|
5. |
Position the cover.
|
6. |
Fit the cover with the 8 retaining bolts, not the bolt securing the cover for the temperature sensor.
Tightening torque: 25 Nm (18.5 lbf ft). |
7. |
Fit the temperature sensor's cover.
Tightening torque: 25 Nm (18.5 lbf ft). |
8. |
Connect the hoses to the transmission. Make sure that they do not rest against the subframe.
|
9. |
Fit the bracket for the engine mounting.
|
10. |
Connect the ground cable.
|
11. |
Fit the engine pad.
|
12. |
Fit the air shields.
|
13. |
Lower the car and remove the lifting beam.
|
14. |
Connect the breather hose.
|
15. |
6-cyl:
Fit the engine covers.
|
16. |
Fill up with transmission fluid.
|
17. |
Warm up the engine and transmission. Check the fluid level and operation of the transmission.
|