Lock cylinder
| Lock cylinder |
| To remove |
| 1. |
Disconnect the battery's negative cable.
|
|
| 2. |
Remove the cover over the ignition switch.
|
|
| 3. |
Remove the rear middle console.
|
|
| 4. |
Set the ignition key in position straight ahead (OFF). Using a small screwdriver, disconnect the lock cylinder.
|
|
| 5. |
Pull the lock cylinder straight up.
|
|
| Fitting |
| 1. |
Check that the ignition key is in position straight ahead (OFF).
|
|
| 2. |
Press in the locking heel and insert the lock cylinder.
|
|
| 3. |
Fit the rear middle console.
|
|
| 4. |
Fit the cover over the ignition switch.
|
|
| 5. |
Connect the battery's negative cable. 471-
|
|
This project is supported by memberships and donations. If you use this site, please consider Joining SCNA and/or making a donation.
Our Friends
