Brake servo unit, left-hand drive car
Brake servo unit, left-hand drive car |
Removal |
1. |
Remove the bar fixed between
the spring struts.
|
2. |
Remove the air canister over the throttle body.
|
3. |
Disassemble the master cylinder.
|
4. |
Remove the vacuum hose from the brake servo.
|
5. |
Disconnect the electrical distribution box and move it out of the way to improve
access.
|
6. |
Remove the brake servo retaining nuts from the bracket.
|
7. |
Remove the rubber gaiter from the bulkhead partition and pull it towards the
servo container.
|
8. |
Undo the clip on the push rod and lift out the brake servo container.
|
Fitting |
1. |
Position the brake servo
container on the bracket and tighten the four retaining nuts.
|
2. |
Fit the clip on the pushrod and the rubber gaiter on the bulkhead partition.
|
3. |
Fit the electrical distribution box and the vacuum hose.
|
4. |
Fit the master cylinder.
|
5. |
Fit the air canister over the throttle body.
|
6. |
Fit the bar between the spring struts.
|
7. |
Bleed the brake system.
|