SAAB WIS ONLINE

Receiver

Receiver


To remove


1. Drain the AC system of refrigerant.

2. Remove the grille.

3. Unplug the pressure switch's connector. In hot-climate markets the AC system is equipped with two pressure switches.


4. Remove the bolts securing the pipes to the receiver.

5. Remove the bolt securing the receiver to the holder on the condenser.

6. Lift up the receiver.


7. Plug the openings.

8. Unscrew the pressure switch or switches. It/They should be transferred to the new receiver.


To fit



1. Fit new O-rings on the connections for the pressure monitor(s) on the receiver. Lubricate the O-rings with synthetic vaseline.

2. Screw the pressure switch or switches to the new receiver.

3. Place the receiver in its holder.


4. Fit new O-rings on the receiver's pipes. Lubricate the O-rings with synthetic vaseline.

5. Fit the pipes and tighten the screws.

Tightening torque: 9 Nm (6.6 lbf ft)

6. Tighten the bolt securing the receiver in the holder on the condenser.

7. Plug in the connector(s) on the pressure monitor(s) (two pressure monitors in hot-climate markets).

8. Fill up with compressor oil, carry out vacuum pumping of the AC system and fill up with refrigerant.


9. Refit the grille.