No communication between the ACC control module and the ISAT.
|
|
No communication between the ACC control module and the ISAT.
|
|
1.
|
Check whether communication can be established between the main instrument display panel and the SID. If not, proceed to point 3.
|
|
2.
|
Connect a BOB to the ACC control module and check the voltage across BUS+ (pin 11) and ground. Also check the voltage across BUS- (pin 13) and ground. In both cases a reading of about 2.5 V should be obtained. If not, proceed to point 4.
|
|
3.
|
Check the data link connector for loose or displaced pins. Check the voltage across BUS+ (pin 1) and ground and across BUS- (pin 9) and ground. In both cases a reading of about 2.5 V should be obtained. If not, check the wiring for continuity and shorting. Locate and rectify the break or short circuit.
|
|
4.
|
Check the ACC control module and the wiring harness side for pin slide-out. Proceed to section
for further measures if the ACC panel does not go out when the Black Panel button is pressed.
|
