Replacement of rear door window lifts
|
|
Replacement of rear door window lifts
|
|
1.
|
Remove the door trim. See
Service Manual 8:2 "Interior equipment"
.
|
|
2.
|
Remove the water barrier.
|
|
3.
|
Use a pair of long-nose pliers to remove the clip at the rear end of
the external window seal and then withdraw it by hand (a clip is also
fitted at the front end).
|
|
4.
|
Remove the rear guide channel retaining screw.
|
|
5.
|
Lower the window about 10 cm until the window retainer is visible
through the upper holes in the door on the inside.
|
|
6.
|
Use two strips of tape to fasten the window glass in the frame.
|
|
7.
|
Unplug the electric motor connector.
|
|
8.
|
Drill out the heads of the five blind rivets (8.5 mm bit).
|
|
9.
|
Drive the rivets out of the door panel, using a 4 mm drift. Hold the window lift
steady.
|
|
10.
|
Remove the window lift and motor assembly from the window retainer.
Withdraw the assembly rearwards in the door, tilt it downwards and lift
it out of the door.
|
Important
|
|
Since the window lift and window-lift motor comprise a single unit it
is not possible replace them separately.
|
|
|
|
Fit in reverse order.
|
Note
|
|
This work will be facilitated if a heavy-duty pop rivet tool is used.
|
