SAAB WIS ONLINE

Door handle, front door

Door handle, front door

To remove


1. Open the door.


2. Remove the door trim, see Door trim, front door .

3. Remove the plastic water barrier.

4. Remove the pull rod between the door handle and door lock from the door side and leave it suspended.


5. Loosen the guide channel lower retainer bolt and angle out the channel without releasing the retainer at the top (plug-in retainer).

Note

3D, pull the guide rail slightly downward before angling it out.


6. Remove the pull rod, between the lock cylinder and the door lock, from the lock.

Note

The lock cylinder is only present in the driver's door.


7. Remove the lock nut with plate from the rear of the door handle.

8. Guide out the push rod, between the exterior handle and the lock, from the lock.

9. It may be necessary to remove the lock, 3 bolts.

10. Angle the handle out of the door.

11. Pull of the retainer clip securing the microswitch and unhook it.


To fit

Fit in reverse order.

Important

Make sure the water drainage plastic is tight against the inner panel of the door and that it is not damaged.