SAAB WIS ONLINE

DVD unit (729), 5D

DVD unit (729), 5D

Important

The optic cables must be handled carefully so as not to distort the signal.

• It is extremely important that the two leads in the connector are not mixed up.

• The cables cannot be spliced.

• The lead must not be bent to form a curve with a radius of less than 25 mm.

• The lead must not be subjected to temperatures greater than 185°F (85°C).

• The lead ends should be kept free from dirt.

• The lead must not be subjected to blows that could cause the transparent plastic to whiten, thereby reducing light intensity. This could cause disruptions in communication.

• The lead should not be stretched across a sharp edge, which would cause increased damping of the signal.


Warning

The red visible light is of laser class 1. Do not look directly into the optic fibre or the control module connector at close range. At a distance of less than 20 mm from your eyes to the light source, your eyes could be damaged.


To remove

Before removing the unit, perform procedures before removing a control module .


1. Remove the cover.


2. Remove the luggage compartment floor.

3. Remove the DVD unit cover.

Important

Take care when releasing the locking mechanism on the connector so as not to damage the connector. Pull the halves straight apart to avoid bending the pins. For further information regarding connectors, refer to Connectors, handling and inspection .



4. Unplug the connector.

5. Lift out the DVD unit.


To fit


1. Put in place the DVD unit.

Important

Take care when plugging in the connector so as not to damage or press out the pins/sleeves in the connector. For further information regarding connectors, refer to Connectors, handling and inspection .


2. Plug in the connector.


3. Fit the DVD unit cover.

4. Fit the luggage compartment floor.


5. Fit the cover.

6. Carry out actions after replacement of control module .

7. Check the function.