Changing the engine oil and filter |
1. | Remove the upper engine cover. |
2. | Disconnect the hose from the throttle body vacuum box. |
3. | Unplug the EGR valve connector. |
4. | Undo the filter cap. Use 30 31 382 Sleeve, oil filter. |
5. | Raise the car and remove the lower engine cover. |
6. | Place a suitable receptacle under the car. Undo the drain plug and drain the oil. |
7. | Fit the oil plug with a new seal. Tightening torque 18 Nm (13 lbf ft) |
8. | Fit the lower engine cover. |
9. | Lower the car and remove the filter cap and filter element. Catch any oil spills with a rag. |
10. | Fit the filter element and the cap placing a new O-ring on the filter cap. Apply engine oil to the O-ring. Tightening torque 25 Nm (18 lbf ft) |
11. | Connect the vacuum hose to the throttle body vacuum box. |
12. | Plug in the EGR valve. |
13. | Fill with engine oil, see Recommended oil grade. |
14. | Start the engine and let it run for approximately 30 seconds. Switch off the engine. |
15. | Wait 3 - 5 min. Check the oil level and top up if necessary. |
16. | Fit the upper engine cover. |