The following points must be followed when working on xenon headlamps: |
• | Work on the headlamp assemblies should only be carried out by authorised service workshops.
|
• | All work must be carried out according to the instructions provided and with all necessary care. Risk of personal injury if handled improperly.
|
• | The ignition must always be in LOCK position when replacing components.
|
• | Faulty internal leads in the headlamp assemblies must be replaced in their entirety and not repaired.
|
• | Power to the headlamp assembly must be cut off by unplugging the connector before starting work on it.
|
• | Under no circumstances may power be supplied to the headlamp assembly if its protective cover is off.
|
• | The xenon lamp must not be turned on without being correctly fitted in the headlamp assembly with its protective cover in place.
|
• | Always use protective goggles and gloves when handling the xenon lamp as it is highly pressurised.
|
• | The xenon lamp contains mercury and must therefore be turned in for destruction.
|