Bumper shell, front |
To remove |
1. | Remove the upper radiator member's clips (A) and bolts (B) |
2. | Raise the car. |
3. | Remove the bumper bolts (C) in the wing liner.
|
4. | Remove the spoiler shield's bolts (A). Unplug the connector (B) and remove connector (C). Cars with headlamp washers: Detach the washer hose. Suspend it and seal as necessary. |
5. | Pull the corner of the bumper shell (A) loose from the holder's mountings. |
6. | Lift off the bumper shell. |
To fit |
1. | Check that the cellular block is in place in the shell.
|
2. | Position the bumper. Press the shell back and press the shell clips into the holder (A). |
3. | Fit the bumper bolts (C) to the wing liner.
|
4. | Fit the clips (A) and bolts (B) to the upper radiator member.
|
5. | Fit the connector (C) and plug in connector (B). Fit the spoiler shield bolts (A). Cars with headlamp washers: Fit the washer hose. |
6. | Lower the car and check the fit of the bumper shell. |