Calibration of pinch protection |
Note | ||
First ensure the car is equipped with pinch protection. Lift up the window lift button. | ||
Cars with pinch protection: the button has two positions. | ||
Cars without pinch protection: the button has one position. |
|
Procedure |
Note | ||
Only one control module may be calibrated at a time owing to voltage variations. |
1. | Close the window. CV: Close the door and soft top. |
2. | Reset the pinch protection by removing and fitting fuse F5 from the instrument panel electrical centre (IPEC). The pinch protection for both door modules is now reset and both front windows can be programmed. |
3. | Start the car. |
4. | Lower the window fully. Hold the button depressed during the entire operation.
|
5. | Raise the window fully. Hold the button up during the entire operation. Wait for at least 1 second when the window is in the top position.
|
6. | Lower the window fully. Hold the button depressed during the entire operation.
|
7. | Raise the window fully. Hold the button up during the entire operation. Wait for at least 1 second when the window is in the top position.
|
8. | When calibration has been completed an audible confirmation is heard. In the event that there is no audible confirmation, repeat the procedure. |