| To remove |
| 1. | Remove the upper radiator member's clips (A) and bolts (B)  | |
| 2. | Raise the car. | |
| 3. | Remove the bumper bolts (C) in the wing liner.
 | |
| 4. | Remove the spoiler shield's bolts (A). Unplug the connector (B) and remove connector (C). Cars with headlamp washers: Detach the washer hose. Suspend it and seal as necessary.  | |
| 5. | Pull the corner of the bumper shell (A) loose from the holder's mountings.  | |
| 6. | Lift off the bumper shell. | |
| To fit |
| 1. | Check that the cellular block is in place in the shell.
| |
| 2. | Position the bumper. Press the shell back and press the shell clips into the holder (A).  | |
| 3. | Fit the bumper bolts (C) to the wing liner.
| |
| 4. | Fit the clips (A) and bolts (B) to the upper radiator member.
| |
| 5. | Fit the connector (C) and plug in connector (B). Fit the spoiler shield bolts (A). Cars with headlamp washers: Fit the washer hose. | |
| 6. | Lower the car and check the fit of the bumper shell. | |