| Note | ||
Before adjusting: Check that none of the suspension components are damaged. |
| 1. | Release the handbrake. | |
| 2. | Raise the car so the wheels are suspended freely and the spring is fully extended. | |
| 3. | Remove the wheel. | |
| 4. | Remove the air deflector. | |
| 5. | Remove the attachment for the handbrake cable. | |
| 6. | Unplug the connector from the wheel sensor. | |
| 7. | VIN X3025752-: Remove the wheel sensor cable from its holder. | |
| 8. | VIN X3025752-: Remove the mounting for the wheel sensor and brake pipe. | |
| 9. | Blow clean around the wheel hub. | |
| 10. | Undo the wheel hub nuts (4x) approx. 7 turns. Use a 45 mm long 15 mm socket with 3/8" drive, part number 30 34 444, and an extension piece with ball. | |
| 11. | Blow thoroughly clean in the space between the hub and link arm.
| |
| 12. | Fit a 0.3 mm shim top or bottom. If the camber is too much towards +: Fit a shim at the bottom. If the camber is too much towards -: Fit a shim at the top.
 | |||||||
| 13. | Tighten the hub nuts (4x) Tightening torque: 50 Nm +30° (37 lbf ft +30°)  | |
| 14. | VIN X3025752-: Fit the mounting for the wheel sensor and the brake pipe. Tightening torque 24 Nm (18 lbf ft) | |
| 15. | VIN X3025752-: Fit the wheel sensor cable to the mounting. | |
| 16. | Plug in the connector to the wheel sensor. | |
| 17. | Fit the attachment for the handbrake cable. Tightening torque: 8 Nm (6 lbf ft) | |
| 18. | Fit the air deflector. | |
| 19. | Fit the wheel. | |
| 20. | Apply the handbrake. | |
| 21. | Check wheel alignment. | |