Airbag, driver

 Warning

Read the Safety and handling directions and Before changing a control module before starting work.

 To remove


1.Ignition switch in the OFF position.
2.Remove the airbag, 2 screws and plugs.
3.Lift out the airbag slightly from the steering wheel and detach the connectors from the Velcro tape.
4.Disconnect the wires on the back of the airbag.
 To fit


1.Plug in the connectors at the back of the airbag.
2.Attach the connectors to the Velcro tape.
3.Fit the airbag in the steering wheel, 2 screws and plugs.
4.Switch on the ignition and check the SRS and control module as follows:

Connect the diagnostic tool to the diagnostic socket under the dashboard. Clear any diagnostic trouble codes that are present.

Turn the ignition off and on again. Wait at least 10 seconds with the ignition on.

Check whether a diagnostic trouble code is shown:

If a diagnostic trouble code is shown:

Carry out fault diagnosis in accordance with the directions given for each DTC.

If no diagnostic trouble code is shown:

Disconnect the diagnostic tool.