Selector lever housing |
To remove |
1. | Remove the centre and floor consoles, see Centre console Remove the air duct to the rear air vent. |
2. | Remove the circlip and the anti-rattle clip. |
3. | Drive out the pin while removing the end of the cable from the ball. |
4. | Remove the screws securing the selector lever housing.
|
5. | Unplug the selector lever housing's connector. |
6. | Lift up the selector lever housing, undo the cable ties securing the wiring harness to the ignition switch and airbag, and unplug the electrical connection to the ignition switch. |
7. | Remove the clamp located beside the locking catches.
|
8. | Carefully press the catches securing the cable ferrule towards each other and remove the cable from the bracket. |
9. | Lift out the selector lever housing. |
Fitting |
1. | Fit the selector lever housing in place. |
2. | Connect the cable to the selector lever housing and fit the clamp. |
3. | Plug in the electrical connection to the ignition switch while putting the selector lever housing in place. |
4. | Refit the 2 cable ties for the wiring harness. |
5. | Push in the pin at the same time as the ball enters the end of the cable. |
6. | Fit the circlip and the anti-rattle clip. |
7. | Connect the air duct and tighten the four retaining bolts of the lever housing.
Tightening torque: 8 Nm (6 lbf ft) |
8. | Fit the centre and floor console, see group 8 Body, climate system, Interior equipment. |
9. | Adjust the position of the cable. |