Centre console |
To remove |
1. | Manual gearbox: Lift up the gear lever gaiter. Automatic transmission: Remove the edging using 82 93 474 Removal tool. |
2. | Remove the compartment or ashtray with holder using a screwdriver and 82 93 474 Removal tool. See Ashtray. |
3. | Remove the gear lever cover, 2 screws. |
4. | Unplug the connector for the central locking system switch.
|
5. | Lift up the gear lever gaiter and undo the connectors for the seat heating, seat ventilation and cigarette lighter switches.
|
6. | Remove the rear section of the centre console by removing the screw on the top. Then lift straight up and unplug the connector. |
7. | Select reverse (manual) or P (automatic) and remove the key. |
8. | Rotate and lift up the theft protection antenna unit (bayonet fitting) from the ignition switch and unplug the connector. Insert the key and select neutral. |
9. | Disconnect the switch for the electric window lifts and unplug the connectors.
|
10. | Remove the screws holding the upper part of the centre console, 6 screws. Lift out the upper part of the centre console. |
11. | Fold back the carpets and remove the front screws, 2 pcs. |
12. | Remove the rear screws, 2 pcs. |
13. | Lift and remove the centre console. |
To fit |
1. | Lift the centre console into place.
|
2. | Screw on the centre console front and back, 4 screws. Start with the one at the front left, which is used as a guide. |
3. | Refit the carpets. |
4. | Lift the upper part of the centre console backwards. At the same time, carefully guide the wires into place. Be careful with the lead for the theft protection system.
|
5. | Screw the upper part of the centre console in place, 6 screws. |
6. | Refit the switch for the electric window lifts and clip the handbrake gaiter back into place. |
7. | Plug in the connectors in the rear section of the centre console and fit the rear section. Fit the upper screw. |
8. | Reconnect the central locking system connector. |
9. | Plug in the connector for the seat heating, seat ventilation and cigarette lighter switches.
|
10. | Refit the gear lever cover, 2 clips at the back and 2 screws at the front. |
11. | Refit the compartment or ashtray with holder. |
12. | Manual gearbox: Refit gear lever gaiter. Automatic gearbox: Fit the rim around the gear lever housing. |
13. | Select reverse (manual) or P (automatic) and remove the key. |
14. | Plug in the connector for the theft-protection antenna unit and fit it (bayonet fitting). |