DTC B3155 |
Diagnostic Instructions |
• |
Perform the Diagnostic System Check - Vehicle prior to using this diagnostic procedure. |
• |
Review Strategy Based Diagnosis for an overview of the diagnostic approach. |
• |
Diagnostic Procedure Instructions has overviews of all diagnostic categories. |
DTC Descriptor |
Diagnostic Fault Information |
Circuit | Short to Ground | Open/High Resistance | Short to Voltage | Signal Performance |
Passenger Door Handle Lock Switch Signal |
B3155 00 |
1 |
1 |
- |
Passenger Door Handle Lock Switch Ground |
- |
1 |
- |
- |
1. Door Handle Lock Switch Malfunction |
Circuit/System Description |
Conditions for Running the DTC |
Conditions for Setting the DTC |
Action Taken When the DTC Sets |
Conditions for Clearing the DTC |
• |
This DTC will be current for as long as the fault is present. |
• |
When the fault is no longer present, the DTC will be a history DTC. |
• |
A history DTC will clear after 50 ignition cycles. |
Reference Information |
• |
Circuit Testing
|
• |
Connector Repairs
|
• |
Testing for Intermittent Conditions and Poor Connections
|
• |
Wiring Repairs
|
Circuit/System Verification |
Circuit/System Testing |
1. |
Ignition OFF, disconnect the harness connector at the T10N Keyless Entry Antenna - Passenger Door Handle. |
2. |
Ignition ON, verify the scan tool Exterior Passenger Door Handle Proximity Sensor parameter is Inactive. |
3. |
If not the specified value, test the signal circuit terminal 3 for a short to ground. If the circuit tests normal replace the K84 Keyless Entry Control Module. |
4. |
Connect the a 3 A jumper harness between the signal circuit terminal 3 and ground. Verify the scan tool Exterior Passenger Door Handle Proximity Sensor parameter is Active. |
5. |
If not the specified value, test the signal circuit terminal 3 for an open/high resistance. If the circuit tests normal replace the K84 Keyless Entry Control Module. |
6. |
If all circuits test normal, replace the T10N Keyless Entry Antenna - Passenger Door Handle. |
Repair Instructions |
• |
Front Side Door Outside Handle Replacement (Base)
|
• |
Control Module References for keyless entry control module replacement, setup and programming |