DTC C0298 |
Diagnostic Instructions |
• |
Perform the Diagnostic System Check - Vehicle prior to using this diagnostic procedure. |
• |
Review Strategy Based Diagnosis for an overview of the diagnostic approach. |
• |
Diagnostic Procedure Instructions provides an overview of each diagnostic category. |
DTC Descriptors |
Circuit/System Description |
Conditions for Running the DTC |
Conditions for Setting the DTC |
Action Taken When the DTC Sets |
Conditions for Clearing the DTC |
• |
The parking brake control module clears the history DTC when a current DTC is not detected in 40 ignition cycles. |
• |
The condition for setting the DTC is no longer present. |
• |
The park brake control switch button is released using the scan tool. |
Diagnostic Aids |
Reference Information |
• |
Circuit Testing
|
• |
Connector Repairs
|
• |
Testing for Intermittent Conditions and Poor Connections
|
• |
Wiring Repairs
|
Circuit/System Verification |
1. |
Verify DTC C0293 is not set. |
2. |
If DTC C0293 is set, refer to DTC C0293. |
3. |
Command the Parking Brake Cable Service Release to Released with a scan tool. The BRAKE light should turn off and the Park Brake Status on the scan tool should display Released. |
4. |
If the BRAKE light does not turn off or the Park Brake Status does not display Released replace the K83 Parking Brake Control Module. |
Repair Instructions |