Electronic Parking Brake Control Module Replacement

 

Callout Component Name

Preliminary Procedure

1. Release the electric parking brake using electrical release:
1.1. Set ignition in Run mode and put your foot on top of the service brake.
1.2. Press the parking brake switch down and hold for 5 seconds, then a solid yellow telltale is shown on instrument panel.
1.3. Press the parking brake switch again within 5 seconds, then a flashing yellow telltale is shown on instrument panel.

2. Release the electric parking brake using manual release:
2.1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle.
2.2. Remove the tire and wheel assembly. Refer to Tire and Wheel Removal and Installation

2.3. Remove the rear wheelhouse panel liner. Refer to Rear Wheelhouse Panel Liner Replacement.

2.4. Remove the rubber plug. (Arrow)
2.5. Using a square tool with measure 3,2 mm (1/8") release the tension of the cable.
1

 Electronic Parking Brake Control Module Cable
2

 Electronic Parking Brake Control Module Clip (Qty: 2)
3

 Electronic Parking Brake Control Module Nut (Qty: 3)

Refer to Fastener Caution.

Tighten

9.5 Nm (84 lb in)
4

 Electronic Parking Brake Control Module

Procedure

Program the electronic parking brake control module. Refer to Electronic Parking Brake Control Module Programming and Setup.