The following service procedures require either a programming or a setup event performed for a complete repair.

Electronic Suspension Control Module Replacement

If the electronic suspension control module needs to be replaced, the following procedures must be performed:

1.	Connect a scan tool to the vehicle and access SPS. Refer to Service Programming System (SPS).

2.	Perform the SPS function Electronic Suspension Control Module - Programming and follow the on-screen instructions.

3.	Perform the SPS function Electronic Suspension Control Module - Configuration & Setup and follow the on-screen instructions.

4.	Clear DTCs after completing the programming procedure.

Electronic Suspension Control Module Reprogramming

If the electronic suspension control module needs to be replaced, the following procedures must be performed:

1.	Connect a scan tool to the vehicle and access SPS. Refer to Service Programming System (SPS).

2.	Perform the SPS function Electronic Suspension Control Module - Programming and follow the on-screen instructions.

3.	Clear DTCs after completing the programming procedure.