The following service procedures require either a programming or a setup event performed for a complete repair.

The following criteria must be met before performing the programming or learning procedure:

•	The vehicle must be placed on a flat level surface.

•	There must be no occupants in the vehicle.

•	Any additional cargo weight in the rear compartment must be removed.

•	All doors must be closed.

Headlamp Control Module Replacement

If the headlamp control module needs to be replaced, the following procedures must be performed:

1.	Connect a scan tool to the vehicle and access SPS. Refer to Service Programming System (SPS)

2.	Perform the SPS function Headlamp Control Module - Programming and follow the on-screen instructions.

3.	Perform the SPS function Headlamp Control Module - Configuration & Setup and follow the on-screen instructions. On the screen Control Module - Configuration and Setup Function(s), select both control module Configuration/Reconfiguration and the appropriate control module Setup.

4.	Clear DTCs after completing the programming procedure.

Headlamp Control Module Reprogramming

Do not reprogram the headlamp control module unless directed by a service procedure or a service bulletin.

1.	Connect a scan tool to the vehicle and access SPS. Refer to Service Programming System (SPS)

2.	Perform the SPS function Headlamp Control Module - Programming and follow the on-screen instructions.

3.	Clear DTCs after completing the programming procedure.

Setup for Component Replacement

The replacement of one or more components will require a setup procedure for complete repair.

If the headlamp leveling sensor is replaced, perform the scan tool learn procedure Automatic Headlamp Leveling Sensor Learn.