The following service procedures require either a programming or a setup event performed for a complete repair.

Parking Assist Control Module Replacement

If the parking assist control module needs to be replaced, the following procedures must be performed:

1.	Connect a scan tool to the vehicle and access SPS. Refer to Service Programming System (SPS)

2.	Perform the SPS function Parking Assist Control Module - Programming and follow the on-screen instructions.

3.	Perform the SPS function Parking Assist Control Module - Configuration & Setup and follow the on-screen instructions.

4.	Clear DTCs after completing the programming procedure.

Parking Assist Control Module Reprogramming

Do not reprogram the parking assist control module, unless directed by a service procedure, or a service bulletin.

1.	Connect a scan tool to the vehicle and access SPS. Refer to Service Programming System (SPS)

2.	Perform the SPS function Parking Assist Control Module - Programming and follow the on-screen instructions.

3.	Clear DTCs after completing the programming procedure.