The following service procedures require either a programming or a setup event performed for a complete repair.

Transmission Control Module Replacement

If the transmission control module (TCM) needs to be replaced, the following procedures must be performed:

1.	Connect a scan tool to the vehicle and access SPS. Refer to Service Programming System (SPS).

2.	Perform the SPS function Transmission Control Module - Programming and follow the on-screen instructions.

3.	Perform the SPS function Transmission Control Module - Configuration & Setup and follow the on-screen instructions. On the screen Control Module - Configuration and Setup Function(s), select both control module Configuration/Reconfiguration and the appropriate control module Setup.

4.	Clear DTCs after completing the programming procedure.

Transmission Control Module Reprogramming

Do not reprogram the transmission control module (TCM) unless directed by a service procedure or a service bulletin.

1.	Connect a scan tool to the vehicle and access SPS. Refer to Service Programming System (SPS).

2.	Perform the SPS function Transmission Control Module - Programming and follow the on-screen instructions.

3.	Clear DTCs after completing the programming procedure.

Setup for Component Replacement

The replacement of following components will require to reset learned values and N position calibration, refer to Transmission Adaptive Functions.

•	Automatic Transmission

•	Control valve body

The replacement of following components will require N position calibration, refer to Transmission Adaptive Functions.

•	Transmission control replacement

•	Range selector lever