Measuring Frequency

 

Special Tools

 EL 39200Digital Multimeter (DMM)

For equivalent regional tools, refer to Special Tools.

Refer to Test Probe Caution

The following procedure determines the frequency of a signal.

Note

Connecting the Digital Multimeter (DMM) to the circuit before pressing the Hz button will allow the DMM to autorange to an appropriate range.



1. Apply power to the circuit.
2. Set the DMM to the V (AC) position.
3. Connect the positive lead of the DMM to the circuit to be tested.
4. Connect the negative lead of the DMM to a good ground.

5. Set to Hz on the DMM.
6. The DMM will display the frequency measured.