Bosch Connectors (2.8 JPT) |
• |
EL-38125-580 Terminal Release Tool Kit
|
• |
J-38125-557 Terminal Release Tool
|
Terminal Removal Procedure |
1. |
Pull out the slider on the connector position assurance (CPA) until it is at the end of its travel. |
2. |
Disconnect the connector from the component. |
3. |
Remove the wire dress cover, if necessary. |
4. |
Push the wire side of the terminal that is being removed toward the connector and hold it in position. |
5. |
Insert the J-38125-557 into the 2 cavities on each side of the terminal at the front of the connector and push until you feel the tool disengage the terminal retainers. |
6. |
Carefully pull the terminal out of the connector. Always remember never use force when pulling a terminal out of a connector. If the terminal is difficult to remove, repeat the entire procedure. |
7. |
Repair the terminal by following the Repairing Connector Terminals procedure. |
8. |
Insert the repaired terminal back into the cavity. Repeat the diagnostic procedure to verify the repair and reconnect the connector bodies. |