Delphi Connectors (Push To Seat) |
Terminal Removal Procedure |
1. |
Remove the terminal position assurance (TPA) device, the connector position assurance (CPA) device, and/or the secondary lock. |
2. |
Separate the connector halves (1). |
3. |
Use the proper pick or removal tool (1) in order to release the terminal. |
4. |
Gently pull the cable and the terminal (2) out of the back of the connector. |
5. |
Re-form the locking device if you are going to reuse the terminal (1). |
6. |
Repair the terminal by following the Repairing Connector Terminals procedure. |
7. |
Insert the repaired terminal back into the cavity. Repeat the diagnostic procedure to verify the repair and reconnect the connector bodies. |
Terminal Insertion Procedure |
1. |
In order to reuse a terminal or lead assembly, refer to Wiring Repairs. |
2. |
Ensure that the cable seal is kept on the terminal side of the splice. |
3. |
Insert the lead from the back until it catches. |
4. |
Install the TPA, CPA, and/or the secondary locks. |