Special Tools
| • |
EL-38125-580 Terminal Release Tool Kit
| |
| • |
J-38125-12A Terminal Release Tool
| |
For equivalent regional tools, refer to Special Tools.
| Terminal Removal Procedure |
| 1. |
Locate the assist lever and lock on the top of the connector. | |
| 2. |
While depressing the lock, pull the lever over and past the lock. | |
| 3. |
Disconnect the connector from the component. | |
| 4. |
Locate the dress cover locking tabs at the rear of the connector. Use a small flat-blade tool to release the locking tabs. Repeat this procedure for the other locking tab. | |
| 5. |
Once the locking tabs are unlocked, slide the inner connector out of the rear of the connector housing. | |
| 6. |
Use the J-38125-12A tool to release the terminals by pressing on the tang. | |
| 7. |
While holding the removal tool in place, gently pull the wire out of the back of the connector. Always remember never use force when pulling a terminal out of a connector. | |
| 8. |
Repair the terminal by following the Repairing Connector Terminals procedure. | |
| 9. |
Insert the repaired terminal back into the cavity. Repeat the diagnostic procedure to verify the repair and reconnect the connector bodies. | |