Special Tools
J-38125 Terminal Repair Kit| Removal Procedure |
| 1. |
Using your thumbs press down and slide the red CPA away from the connector lever. | |
| 2. |
Using your thumb press down on the locking tab and move the lever to the released position. | |
| 3. |
Using terminal tool J-38125-11A or equivalent, release the wire dress cover locking tabs.  | |
| 4. |
Pivot connector wire dress cover while removing from the connector body. | |
| 5. |
Using terminal tool J-38125-11A or equivalent, remove the TPA by lifting straight off the connector body.  | |
| 6. |
Using terminal release tool J-38125-215A, place the tip of the tool on the outside edge next to the terminal and depress the lock tab and remove the rear of the connector body. | |
| Terminal Repair Procedure |
Use the appropriate terminal and crimper in the J-38125 in order to replace the terminal.