Tyco/AMP Connectors (0.25 Cap) |
• |
EL-38125-580 Terminal Release Tool Kit
|
• |
J-38125-24 Terminal Release Tool
|
Terminal Removal Procedure |
1. |
Disconnect the connector from the component by pressing down on the connector position assurance (CPA). |
2. |
Use a small flat-bladed tool to loosen the TPA catch. Insert the screwdriver in the small slit on the side of the connector and press up until the catch loosens from the connector body. The TPA catch should lift slightly. Do not try to remove the TPA.
|
3. |
Repeat the process for the other side of the connector. |
4. |
Ensure that the TPA is in the proper position to remove the terminals. |
5. |
While pushing the terminal forward, insert the J-38125-24 in the release cavity above the terminal you are removing, gently pull the wire out of the back of the connector. Always remember never use force when pulling a terminal out of a connector. |
6. |
Repair the terminal by following the Repairing Connector Terminals procedure. |
7. |
Insert the repaired terminal back into the cavity. Repeat the diagnostic procedure to verify the repair and reconnect the connector bodies. |