DTC B0082 |
Diagnostic Instructions |
• |
Perform the Diagnostic System Check - Vehicle prior to using this diagnostic procedure. |
• |
Review Strategy Based Diagnosis for an overview of the diagnostic approach. |
• |
Diagnostic Procedure Instructions provides an overview of each diagnostic category. |
DTC Descriptors |
Diagnostic Fault Information |
Circuit | Short to Ground | Open/High Resistance | Short to Voltage | Signal Performance |
Seat Belt Reminder Sensor Signal |
B0082 02 |
B0082 04 |
B0082 01 |
- |
Seat Belt Reminder Sensor Ground |
- |
B0082 04 |
B0082 04 |
- |
Circuit/System Description |
Conditions for Running the DTC |
Conditions for Setting the DTC |
Action Taken When the DTC Sets |
Conditions for Clearing the DTC |
• |
The DTC will be current for as long as the fault is present. |
• |
When the fault is no longer present, the DTC will be a history DTC. |
• |
A history DTC will clear after 50 ignition cycles. |
Reference Information |
• |
Circuit Testing
|
• |
Testing for Intermittent Conditions and Poor Connections
|
• |
Wiring Repairs
|
• |
Connector Repairs
|
Circuit/System Verification |
1. |
Ignition ON, with the passenger seat unoccupied, verify the scan tool Passenger Seat Occupancy Status parameter is Empty Seat. |
2. |
With the passenger seat occupied, verify the scan tool Passenger Seat Occupancy Status parameter is Occupied. |
Circuit/System Testing |
1. |
Ignition OFF, disconnect the harness connector at the B60 seat belt reminder sensor. |
2. |
Test for less than 30 Ω between the ground circuit terminal 2 and ground. |
3. |
If greater than the specified range, test the ground circuit for an open/high resistance. If the circuit tests normal replace the K36 SDM. |
4. |
Ignition ON, test for 4.75-5.25 V between the signal circuit terminal 1 and ground. |
5. |
If less than the specified range, test the signal circuit for a short to ground or an open/high resistance. If the circuit tests normal replace the K36 SDM. |
6. |
If greater than the specified range, test the signal circuit for a short to voltage. If the circuit tests normal replace the K36 SDM. |
7. |
If all circuits test normal, replace the B60 seat belt reminder sensor. |
Repair Instructions |
• |
Control Module References for SDM replacement, setup, and programming |