DTC P0447 EVAPORATIVE EMISSION CONTROL SYSTEM VENT CONTROL CIRCUIT OPEN

/ 9-2X (9346) / 2005 / 2. Engine / ENGINE (DIAGNOSTICS), 2.0T / Diagnostic Procedure with Diagnostic Trouble Code (DTC) / Fault diagnosis, fault codes / DTC P0447 EVAPORATIVE EMISSION CONTROL SYSTEM VENT CONTROL CIRCUIT OPEN

DTC DETECTING CONDITION:

•

Two consecutive driving cycles with fault

•

GENERAL DESCRIPTION

Important
After repair or replacement of faulty parts, conduct Clear Memory Mode and Inspection Mode .

WIRING DIAGRAM:

CHECK OUTPUT SIGNAL FROM ECM.

Turn ignition switch to ON.

Measure the voltage between ECM and chassis ground.

Connector & terminal

(B84) No. 11 (+) — Chassis ground (−):

Is the voltage more than 10 V?

Yes

CHECK FOR POOR CONTACT.

Check for poor contact in ECM connector.

Is there poor contact in ECM connector?

Yes

Repair poor contact in ECM connector.

•

The malfunction indicator light may light up, however, the circuit is returned to the normal status at the moment. (However, the possibility of poor contact still remains.)

•

Note
In this case, repair the following:
•	Poor contact in drain valve connector
•	Poor contact in ECM connector
•	Poor contact in coupling connector

CHECK HARNESS BETWEEN DRAIN VALVE AND ECM CONNECTOR.

Turn ignition switch to OFF.

Disconnect the connectors from drain valve and ECM.

Measure the resistance of harness between drain valve connector and chassis ground.

Connector & terminal

(R69) No. 2 — Chassis ground:

Is the resistance more than 1 MΩ?

Yes

Repair short circuit to ground in harness between ECM and drain valve connector.

CHECK HARNESS BETWEEN DRAIN VALVE AND ECM CONNECTOR.

Measure the resistance of harness between ECM and drain valve connector.

Connector & terminal

(B84) No. 11 — (R69) No. 2:

Is the resistance less than 1 Ω?

Yes

•

Repair harness and connector.

•

Note
In this case, repair the following:
•	Open circuit in harness between ECM and drain valve connector
•	Poor contact in coupling connector

CHECK DRAIN VALVE.

Measure the resistance between drain valve terminals.

Terminals

No. 1 — No. 2:

Is the resistance 10 — 100 Ω?

Yes

Replace the drain valve.

CHECK POWER SUPPLY TO DRAIN VALVE.

Turn ignition switch to ON.

Measure the voltage between drain valve and chassis ground.

Connector & terminal

(R69) No. 1 (+) — Chassis ground (−):

Is the voltage more than 10 V?

Yes

•

Repair harness and connector.

•

Note
In this case, repair the following:
•	Open circuit in harness between main relay and drain valve
•	Poor contact in coupling connector
•	Poor contact in main relay connector

CHECK FOR POOR CONTACT.

Check for poor contact in drain valve connector.

Is there poor contact in drain valve connector?

Yes

Repair poor contact in drain valve connector.

Contact Service Center.

DTC P0447 EVAPORATIVE EMISSION CONTROL SYSTEM VENT CONTROL CIRCUIT OPEN

CHECK OUTPUT SIGNAL FROM ECM.

Is the voltage more than 10 V?

CHECK FOR POOR CONTACT.

Is there poor contact in ECM connector?

CHECK HARNESS BETWEEN DRAIN VALVE AND ECM CONNECTOR.

Is the resistance more than 1 MΩ?

CHECK HARNESS BETWEEN DRAIN VALVE AND ECM CONNECTOR.

Is the resistance less than 1 Ω?

CHECK DRAIN VALVE.

Is the resistance 10 — 100 Ω?

CHECK POWER SUPPLY TO DRAIN VALVE.

Is the voltage more than 10 V?

CHECK FOR POOR CONTACT.

Is there poor contact in drain valve connector?

Our Friends