REMOVAL

REMOVAL

Release the fuel pressure.

Open the fuel filler lid and remove the fuel filler cap.

Disconnect the ground cable from battery.

Lift up the vehicle.

Remove the under cover.

Drain the engine coolant about 3.0 litres (3.2 US qt, 2.6 Imp qt).

Remove the air cleaner upper cover and air intake boot.

Remove the air cleaner element.

Remove the intercooler.

Disconnect the accelerator cable.

Remove the coolant filler tank.

Remove the power steering pump.

Remove the front side V-belt.

Disconnect the power steering switch connector.

Remove the bolts which secure the power steering pipe brackets to the intake manifold.

Note
Do not disconnect the power steering hose.

Remove the bolts which secure the power steering pump bracket.

Remove the power steering tank from the bracket by pulling it upward.

Place the power steering pump on the right side wheel apron.

Disconnect the emission hose (A) and connector (B) from the PCV hose assembly.

Disconnect the engine coolant hoses from the throttle body.

Disconnect the brake booster vacuum hose.

Disconnect the pressure hose from the intake duct.

Disconnect the engine harness connectors from the bulkhead harness connectors.

Disconnect the connectors from the engine coolant temperature sensor (A), oil pressure switch (B) and crankshaft position sensor (C).

Disconnect the knock sensor connector.

Disconnect the connector from the camshaft position sensor.

Disconnect the connector from the ignition coil.

Disconnect the engine harness fixed by clip (A) from the bracket.

Using ST, disconnect fuel hoses from fuel pipes.

Important
•	Be careful not to spill fuel.
•	Catch fuel from hoses using a container or cloth.

ST 32005086 CONNECTOR REMOVER

Remove the bolts which secure the intake manifold to the cylinder heads.

Remove the intake manifold.