SAAB WIS ONLINE

INSTALLATION

INSTALLATION

Install the crank pulley.

Install the pulley bolt.

To lock the crankshaft, use ST.

ST 32005164 CRANKSHAFT PULLEY WRENCH

Clean the crank pulley thread using compressed air.

Apply engine oil to the crank pulley bolt seat and thread.

Tighten the bolts temporarily with tightening torque of 44 Nm (4.5 kgf-m, 33 ft-lb).

Tighten the crank pulley bolts.

Tightening torque:

127 Nm (13 kgf-m, 94.0 ft-lb)


Confirm that the tightening angle of crank pulley bolt is 45 degrees or more. If the tightening angle of crank pulley bolt is less than 45 degrees, conduct the following procedures.

Important

If the tightening angle of crank pulley bolt is less than 45 degrees, the bolt should be damaged. In this case, the bolt must be replaced.


Replace the crank pulley bolts and clean them.

Crank pulley bolt:

32005529

Clean the crankshaft thread using compressed air.

Tighten the bolts temporarily with tightening torque of 44 Nm (4.5 kgf-m, 33 ft-lb).

Tighten the crank pulley bolts keeping them in an angle between 45 degrees and 60 degrees.

Note

Conduct the tightening procedures by confirming the turning angle of crank pulley bolt referring to the gauge indicated on timing belt cover.


Install the A/C belt tensioner.


Install the V-belt.