INSTALLATION
| INSTALLATION |
| FRONT SIDE BELT |
| Note | ||
|
Wipe off any oil or water on the belt and pulley. |
Install the V-belt (C), and tighten the slider bolt so as to obtain the specified belt tension.
Tighten the lock bolt (A).
Tighten the slider bolt (B).
Tightening torque:
Lock bolt through bolt
25 Nm (2.5 kgf-m, 18.1 ft-lb)Slider bolt
8 Nm (0.8 kgf-m, 5.5 ft-lb)
Stop the engine, and then check the belt tension and adjust it. (With using tension gauge)
Idle the engine for approx. 1 min. to normalize the V-belt. (With using tension gauge)
Stop the engine, and then check the belt tension is within specified value. (With using tension gauge)
Adjust the belt tension until the value within specification. (With using tension gauge)
| REAR SIDE BELT |
Install the belt, and tighten the slider bolt (B) so as to obtain the specified belt tension.
Tighten the lock nut (A).
Tightening torque:
Lock nut (A)
22.6 Nm (2.3 kgf-m, 16.6 ft-lb)
Idle the engine for approx. 5 min. to normalize the V-belt. (With using tension gauge)
Stop the engine, and then check the belt tension and adjust it. (With using tension gauge)
Idle the engine for approx. 1 min. to normalize the V-belt. (With using tension gauge)
Stop the engine, and then check the belt tension is within specified value. (With using tension gauge)
Adjust the belt tension until the value within specification. (With using tension gauge)
This project is supported by memberships and donations. If you use this site, please consider Joining SCNA and/or making a donation.
Our Friends
