REMOVAL
| REMOVAL |
Remove the transmission assembly from the vehicle.
Extract the torque converter clutch assembly.
Remove the input shaft.
Disconnect inhibitor switch connector from stay.
Disconnect the air breather hose.
Remove the oil charge pipe.
Remove the oil cooler inlet and outlet pipes.
Separation of converter case and transmission case.
Remove the oil pump housing.
Take out the high clutch, thrust needle bearing and reverse clutch assembly.
|
(A)
|
High clutch
and reverse clutch assembly
|
|
(B)
|
Thrust
needle bearing
|
Take out the high clutch hub and the thrust bearing.
|
(A)
|
High clutch
hub
|
|
(B)
|
Thrust
needle bearing
|
Take out the front sun gear and the thrust bearing.
|
(A)
|
Front sun
gear
|
|
(B)
|
Thrust
needle bearing
|
Pull out leaf spring without folding.
| Note | ||
|
Remove it while pressing down on lower leaf spring. |
|
(A)
|
Leaf spring
|
|
(B)
|
Retaining
plate
|
Remove snap ring and thrust needle bearing.
|
(A)
|
Snap ring
|
|
(B)
|
Thrust
needle bearing
|
Take out retaining plate, drive plate and driven plate of 2-4 brake.
Take out the thrust needle bearing, planetary gear assembly and the low clutch assembly.
Remove 2-4 brake seal.
Remove snap ring.
|
(A)
|
Snap ring
|
|
(B)
|
2-4 brake
piston
|
Take out 2-4 brake return spring.
Remove the 2-4 brake piston and piston retainer without damaging.
|
(A)
|
2-4 brake
piston
|
|
(B)
|
2-4 brake
piston retainer
|
Pull out the leaf spring without folding.
|
(A)
|
Leaf spring
|
Remove snap ring.
|
(A)
|
Snap ring
|
Take out retaining plate, drive plate, driven plate and dish plate.
Turn the transmission case upside down, and then take out the socket bolts while holding the one-way clutch inner race with hand.
Take out the spring retainer.
Take out the return spring.
Apply compressed air.
Take out the low & reverse piston.
This project is supported by memberships and donations. If you use this site, please consider Joining SCNA and/or making a donation.
Our Friends
