SAAB WIS ONLINE

REMOVAL

REMOVAL

Remove the manual transmission assembly from vehicle.

Remove the back-up light switch and neutral position switch.

Remove the transfer case with extension case assembly.

Remove the transmission case.

Remove the drive pinion shaft assembly.

Remove the main shaft assembly.



Remove the differential assembly.

Drive out the straight pin with ST, and 5th shifter fork.

ST 32005077 STRAIGHT PIN REMOVER


(A)

Straight pin

(B)

5th shifter fork



Remove the plugs, springs and checking balls.

Drive out the straight pin, and pull out 3-4 fork rod and shifter fork.

Note

When removing the rod, keep other rods in neutral. Also, when pulling out the straight pin, remove it toward the inside of case so that it does not hit against the case.



(A)

Straight pin

(B)

3-4 fork rod

(C)

Shifter fork



Drive out the straight pin, and pull out 1-2 fork rod and shifter fork.

Remove the outer snap ring, and pull out the reverse shifter rod arm from reverse fork rod. Then take out the ball, spring and interlock plunger from rod.

And then remove the rod.

Note

When pulling out the reverse shifter rod arm, be careful not to let the ball pop out of arm.


Remove the reverse shifter lever.