Clutch pedal and pedal bracket LHD

Clutch pedal and pedal bracket LHD

1.	Drain the clutch system (brake fluid) through the bleed nipple on the slave cylinder using 88 19 096 Bleeding equipment .

2.	Unplug the connector to the alarm's bonnet switch, if applicable.

3.	Detach the main fuse box and put it to the side.

4.	Detach the supply hose from the master cylinder.

5.	Detach the clip holding the delivery pipe at the master cylinder.

6.	Detach the delivery pipe.

7.	From the engine bay, remove the nut holding the right-hand portion of the clutch pedal bracket to the scuttle panel.

8.	Remove the lower panel and the knee shield under the steering wheel.

9.	Remove the floor air duct and the pedal switch.

10.	Remove the air duct of the side defroster and the cable tie of the wiring harness.

11.	Remove the clip and pin from the clutch pedal.

12.	Remove the nut holding the clutch pedal.

13.	Lift out the right-hand portion of the clutch pedal bracket with the master cylinder.

14.	Detach the clip and remove the auxiliary spring from the clutch pedal.

15.	Loosen the nut under the dashboard slightly.

16.	Remove the nut to the clutch pedal's left-hand bracket on the outside of the scuttle panel.

17.	Pull out the bracket with clutch pedal.

18.	Remove the clutch pedal from the bracket.

To fit

1.	Fit the clutch pedal on the bolt.

2.	Fit and secure the left-hand clutch pedal bracket. Begin with the nut in the engine bay. Tightening torque 24 Nm (18 lbf ft)

3.	Tighten the pedal bracket's retaining nut under the dashboard. Tightening torque 24 Nm (18 lbf ft) Fit the auxiliary spring and clip on the clutch pedal.

4.	Fit the right-hand portion of the clutch pedal bracket with the master cylinder at the scuttle panel and the clutch pedal bolt.

5.	Fit the nut on the clutch pedal bolt, but do not tighten.

6.	Check that the auxiliary spring of the clutch pedal is correctly mounted.

7.	Tighten the right-hand portion of the clutch pedal bracket to the scuttle panel. Tightening torque 24 Nm (18 lbf ft)

8.	Connect the supply hose to the master cylinder.

9.	Connect the delivery pipe and refit the clip.

10.	Fit the main fuse box and connect the alarm's bonnet switch.

11.	Tighten the clutch pedal nut. Tightening torque 47 Nm (35 lbf ft)

12.	Fit the pin and clip to the pedal.

13.	Fit the air duct to the side defroster and secure the wiring harness.

14.	Fit the pedal switch.

15.	Pull back the clutch pedal so that the switch is adjusted to the correct position. If the switch presses the pedal down, there may be malfunctions.

16.	Fit the knee shield, floor air duct and lower panel.

17.	Fill with brake fluid.

18.	Bleed the clutch. See .

19.	Test the clutch and cruise control.