Lock fitting/switch windscreen crossmember
| Lock fitting/switch windscreen crossmember |
| Removing |
The following describes removal of the microswitch on the left side. The right microswitch is removed using the same method.
| 1. |
Lower the soft top.
|
|
| 2. |
Remove the sun visor and the visor support.
|
|
| 3. |
Loosen the windscreen frame seal so that the bolts securing the top part of the windscreen moulding can be accessed.
|
|
| 4. |
Remove the bolts.
|
|
| 5. |
Slightly pull down the windscreen frame moulding and
|
|
| 6. |
Remove the bolts that secure the lock fitting.
|
|
| 7. |
Unplug the connector and remove the lock fitting.
|
|
| 8. |
Bend out the clips and pull out the switch.
|
|
| Fitting |
| 1. |
Fit the switch in the lock fitting and bend back the clips.
|
|
| 2. |
Fit the lock fitting on the windscreen frame and tighten the bolts.
|
|
| 3. |
Plug in the connector.
|
|
| 4. |
Fit the upper part of the windscreen frame moulding and then tighten the bolts.
|
|
| 5. |
Refit the windscreen frame seal. See
Use only soapy water to facilitate fitting of the seal. |
|
| 6. |
Fit the lower part of the windscreen frame moulding.
|
|
| 7. |
Refit the sun visor and the support.
|
|
| 8. |
Connect the diagnostics tool and erase any diagnostic trouble code.
|
|
This project is supported by memberships and donations. If you use this site, please consider Joining SCNA and/or making a donation.
Our Friends
