SAAB WIS ONLINE

Limp-home solenoid

Limp-home solenoid

To remove


1. Remove the engine cover.


2. Remove the cover on the throttle body pedal arm.

3. Remove the rubber seal and unplug the connector.

4. Undo the lower screw (can be difficult to get at) with a magnetic T15 bit.

5. Remove the upper screw.

6. Remove the solenoid. (not available separately)


To fit



1. Fit the solenoid.

2. Screw in the upper screw.

3. Tighten the lower screw (it can be difficult to reach) using a magnetic T15 bit.

4. Spray the connector with Kontakt 61 (part no. 30 04 520). Plug in the connector and fit the rubber seal.

5. Fit the cover on the throttle body pedal arm.

Important

When the limp-home solenoid is removed the throttle body runs in the mechanical limp-home. After fitting, the limp-home mechanism must therefore be reset in accordance with Resetting activated limp-home solenoid .


6. Put the engine cover in place.