P1252
Read the instructions below then
start the fault diagnostic procedure.
Symptom: CHECK ENGINE goes on immediately.
Throttle control in limp-home mode.
Idling speed incorrect.
Cruise control not working.
Throttle Motor. Full PWM in Open Direction and no Motor Current.
Fault symptoms
|
•
|
CHECK ENGINE goes on immediately.
|
|
•
|
Throttle control in limp-home mode.
|
|
•
|
Idling speed incorrect.
|
|
•
|
Cruise control not working.
|
Conditions
The following conditions apply for this DTC:
|
•
|
Crankshaft rotating and main relay voltage exceeding 10V.
|
|
•
|
Throttle motor receiving 100% PWM in open direction but there is no current reaching the motor.
|
Diagnostic help
An electrical fault in the throttle motor circuit is preventing the throttle from opening. Main relay voltage supplying the control module is OK.
Functions in the diagnostic tool related to the fault:
|
•
|
Activate output for throttle motor.
|
See also the description of activations,
, for more information.
Checking the wiring
Jiggle the wiring harness at several points and in different directions to detect intermittent breaks and short circuits. Observe the multimeter, diagnostic tool or test lamp during the check.
