SAAB WIS ONLINE

Temperature detector, auxiliary heater

Temperature detector, auxiliary heater

To remove



1. Remove the heater, see alternatively .

2. Remove the cover for the combustion chamber.

3. Loosen the bolt that secures the plate and the two detectors.


4. Wiggle up the temperature detector and the overheating protection.

5. Remove the cover over the blower fan.


Important

Note the fuel pipe rubber leadthrough.


6. Loosen the four bolts on the control module, remove the cover with the air intake and carefully bend out the control module.

7. Remove the connector and remove the control module from the heater.


8. Open connector B2 and remove the leads from the pins for the temperature detector. Use tool 85 80 110.



To fit



1. Replace the temperature detector and overheating protection. Insert the leads for the pins in connector B2.

Important

Note the positions of the leads when fitting.


2. Fit connector B2 to the control module.


3. Fit the cover with air intake and control module.


4. Fit the cover over the blower fan.

Important

Note the fuel pipe rubber leadthrough.


5. Fit the temperature detector and overheating protection.


6. Fit the bolt and the plate securing the detectors.

7. Fit the cover over the combustion chamber.


8. Fit the heater, see alternatively .