SAAB WIS ONLINE

Test readings, control module connections

Test readings, control module connections




Scope

Values and directions for measuring the voltage levels in the control module are given under the relevant heading.

Remember


Note the test conditions and use common sense when assessing the test result.

The specified values are with the ignition ON unless otherwise stated.

First check that the control module has a power supply and is grounded.

Then check all sensor inputs and signals from other systems.

Finally, check the control module outputs. Remember that the test readings do not indicate whether or not the actuator is in working order.

If any reading is not OK, consult the wiring diagram to trace the leads, connectors or components which should be checked more thoroughly.

The specified test readings refer to those obtained with a calibrated Fluke 88/97.

Test readings in % (+) and ms (+) show the pulse ratio and pulse duration of the signal. A test instrument capable of giving pulse ratio and pulse duration readings must be used. The (+) sign indicates a positive trigger pulse, TRIG+.



Connector


> =greater than ; < = less than ; ~ = alternating current (LP: LOGIC PROBE P = select pulse ; p = visible pulses)

Pin No.

Cable colour

Component/

function

In/out

Test conditions

Across

Test reading

See

1

YE/WH

Right brake light, power supply from TWICE to bulb.

Out

Brake pedal pressed.

1-B-

B+

Lighting and signalling systems



2

GY

Central locking system motor for luggage compartment lock, relay.

Out

Not operated

2-B-

B+

Doors and locks











Activate function with diagnostic tool.

B+ -2

B+



3

BU/YE

Electrically adjustable passenger seat, relay ground.

Out

Ignition ON

3-B-

approx. 1V

Seats











Ignition OFF. Front doors closed.



Not operated

3-B-

B+



4

BN

Starting relay

Out

Ignition key in position ST.

Transponder not OK.

4-B-

B+











Ignition key in position ST.

Transponder OK.

4-B-

<0.5V



5

BN/WH

Seat sensor, passenger seat.

In

Passenger seat occupied.

5-21

<4.2V

Seat belt system









Passenger seat unoccupied.

5-21

5V



6

YE/GY

Locking switch for central locking, centre console.

In

Ignition ON

6-B-

B+ for approx. 0.5 sec.

Doors and locks



7

YE/BN

Unlocking switch for central locking, centre console.

In

Ignition ON

7-B-

B+ for approx. 0.5 sec.

Doors and locks



8

BU/BN

Unlocking with key in passenger door.

In

Ignition ON

B+ -8

B+ for approx. 0.5 sec.

Doors and locks



9

BN

Heated rear seat, request.

In

Ignition ON:

Heated seat button held down.

9-B-

B+

Seats



10

RD

Glass breakage sensor and tilt sensor, power supply.

Out

Sensor not disconnected.

Anti-theft alarm armed.

10-B-

B+





11

RD/WH

Switch for unlocking tailgate/boot lid.

In

Ignition ON

11-B-

B+ for approx. 0.5 sec.

Doors and locks



12

BK/GN

Door switch, left rear door.

In

Ignition ON:

Door closed.

12-B-

B+ for approx. 0.5 sec.



13

BK

Receiver remote control, ground.

In

Always

B+ -13

B+











13-B-

<0.5V



14

BN

Receiver remote control, signal.

In

Remote control not operated.

14-B-

B+











Press lock button.

14-B-

approx. 6V for approx. 0.2 sec.



15

WH

I-bus (-)

In/Out

Ignition ON:

Bus active

15-B-

2-3V



16

YE/GY

Ignition +15, logic.

In

Ignition ON

16-B-

B+

TWICE



17

3D/5D:

BN/RD

CONV:

RD/BN

Ignition +B, logic

In

Ignition ON:

Key in ignition switch

17-B-

B+

TWICE



18

LHD:

BU/RD

LHD/CONV: RD/BK

RHD:

RD/BK



Seat belt switch, driver's side.

In

Ignition ON:

Seat belt on driver's side not buckled

18-B-

<0.5V

Seat belt system











Seat belt buckled



18-B-

B+



19

BU/RD

Tilt sensor signal.

In

Ignition ON

19-B-

1.0V





20

VT/WH

Central locking motors rear doors, operating current for theft security locking

Out

Not operated



B+ -20



B+

Doors and locks









Lock the car.

Then activate function with diagnostic tool.

20-B-

B+









B+ -20

<1V



21

BN/OG

Seat sensor passenger seat, ground.

Out

Ignition ON

B+ -21

B+

Seat belt system



22

OG

Central locking motors doors, operating current for locking

Out

Not operated

B+ -22

B+

Doors and locks









Car must be unlocked.

Then activate function with diagnostic tool.

22-B-

B+











B+ -22

<1V



23

BU/WH

Parking light left rear, power supply from switch.

In

Light switch in position for parking light (pos 1).

23-B-

B+

Lighting and signalling systems



24

YE/GN

High-level brake light, power supply from TWICE to bulb.

Out

Brake pedal pressed.

24-B-

B+

Lighting and signalling systems



25

BU/OG

Left brake light, power supply from TWICE to bulb.

Out

Brake pedal pressed.

25-B-

B+

Lighting and signalling systems



26

BU/YE

Central locking motor driver's door, operating current for unlock

Out

Not operated

B+ -26

B+

Doors and locks











Car must be unlocked.

Then activate function with diagnostic tool.

26-B-

B+











B+ -26

<1V



27

GY/WH

LED, theft security.

Out

Activate function with diagnostics instrument.

B+ -27

approx. 1.95 V



28

RD/WH

Seat belt warning lamp, ground.

Out

Ignition ON

28-B-

<1 V for 6 sec



Seat belt system











Seat belt buckled more than 6 seconds since ignition ON.

28-B-

B+



29

YE

Siren, communication



Out

Ignition ON

29-B-

B+





30



No connection











31



No connection











32

RD/VT

Locking with key in passenger door.

In

Ignition ON

B+ -32

B+ for approx. 0.5 sec.

Doors and locks



33

BU/BN

Unlock with key in driver's door.

In

Ignition ON

B+ -33

B+ for 0.5 sec.

Doors and locks



34

BK

Tilt sensor, ground

In

Always

B+ -34

B+













34-B-

<0.5V



35

BK

Luggage compartment switch

In

Ignition ON:

Tailgate closed.

35-B-

B+ for approx. 0.5 sec.











Tailgate open.

35-B-

<0.1V



36

BK/GN

Door switch; right rear door.

In

Ignition ON:

Door closed.

36-B-

B+ for approx. 0.5 sec.













Door open.

36-B-

<0.1V



37

BK

Signal ground

In

Always

B+ -37

B+

TWICE













37-B-

<0.5V



38

GN

I-bus (+)

In/Out

Ignition ON:

Bus active

38-B-

2-3V



39

OG/BK

Immobilizer; code from antenna unit by the ignition lock.

In

Ignition ON

39-B-

B+











Ignition OFF.

B+ -39

<0.1V



40



No connection











41

RD/WH

Bonnet switch

In

Ignition ON:

Bonnet closed.

41-B-

B+ for approx. 0.5 sec.











Bonnet open.

41-B-

<0.1V



42

VT

Central locking motor driver's side, operating current for theft prevention locking.

Car must be locked.

Out

Not operated

B+ -42

B+

Doors and locks









Activate function with diagnostics instrument.

42-B-

B+









B+ -42

<1V



43

RD

TWICE, power supply +30.

In

Always +30

43-B-

B+

TWICE











B+ -43

<0.5V



44

VT/WH

Central locking system motor luggage compartment, operating current for theft security locking.



Car must be locked.

Out

Not operated

B+ -44

B+

Doors and locks









Activate function with diagnostics instrument.

44-B-

B+









B+ -44

<1V



45

GN/YE

Parking light left rear, power supply from TWICE to bulb.

Out

Light switch in position for parking light (pos 1).

45-B-

B+

Lighting and signalling systems



46

GN/WH

Parking light right rear, power supply from TWICE to bulb.

In

Light switch in position for parking light (pos 1).

46-B-

B+

Lighting and signalling systems



47

RD

Central locking system, power supply from fuse.

In

Always +30.

47-B-

B+

Doors and locks











Activate any central locking function.

B+ -47

<1V



48

VT

Brake light, power supply from brake light switch.

In

Brake pedal pressed.

48-B-

B+

Lighting and signalling systems



49

BU/YE

Central locking motors rear doors, operating current for unlocking.

Out

Not operated

B+ -49

B+

Doors and locks









Activate function with diagnostics instrument.

49-ground

B+









B+ -49

<1V



50

BK

Antenna unit for immobilizer; power supply.

Out

Ignition ON:

Without transponder

50-B-

B+ for approx. 10 sec.











Ignition ON:

With transponder

50-B-

B+ for approx. 0.1 sec.



51

YE

Luggage compartment opening, relay.



Out

Not operated

51-B-

B+

Doors and locks











Activate function with diagnostic tool.

B+ -51

< 0.5V



52

BU/RD

Heated rear seat, relay.

Out

Activate with diagnostic tool.

52-B-

approx. 1V

Seats











Not operated

52-B-

B+



53



No connection











54



No connection











55

BU/WH

Locking button, driver's door.

In

Ignition ON:

Locking button up.

55-B-

0V

Doors and locks









Locking button down.

55-B-

B+ for approx. 0.5 sec.



56

RD/VT

Locking with key in driver's door.

In

Ignition ON

56-B-

8V for approx. 0.5 sec.

Doors and locks











Key in door lock in locked position.

56-B-

0V



57

WH/BK

Glass breakage sensor, ground

In

Always

B+ -57

B+











57-B-

<0.5V



58

GN/GY

Glass breakage sensor, signal

In

Ignition ON

58-B-

B+ for approx. 0.5 sec.



59

BU/WH

Tailgate switch for disarming anti-theft alarm.

In

Ignition ON:

Not operated

59-B-

B+ for approx. 0.5 sec.









Turn the key to the unlocked position.

59-B-

<0.1V



60

BK/GN

Door switch passenger door, front

In

Ignition ON:

Door closed.

60-B-

B+ for approx. 0.5 sec.









Door open

60-B-

<0.1V



61

GY/GN

Door switch, driver's door.

In

Ignition ON:

Door closed.

61-B-

B+ for approx. 0.5 sec.









Door open

61-B-

<0.1V



62

BK

Central locking system motor, luggage compartment, ground

Out

Not operated

B+ -62

B+

Doors and locks



63



No connection











64



No connection











65

LHD:

RD/BK

RHD:

BU/RD

CONV:

GY/WH



Seat belt switch, passenger side

In

Ignition ON:

Seat belt on passenger side not buckled

65-B-

<0.5V

Seat belt system









Belt buckled

65-B-

B+



66

VT

Central locking motor passenger side front, operating current for theft prevention locking

Out

Not operated

B+ -66

B+

Doors and locks









Lock the car.

Activate function with diagnostics instrument.

66-B-

B+











B+ -66

<1V



67

BU/YE

Central locking system motor, luggage compartment, operating current

Out

Not operated

B+ -67

B+

Doors and locks









Activate function with diagnostics instrument.

67-B-

B+









B+ -67

<1V



68

BN/GN

Parking light right rear, power supply from TWICE to bulb.

Out

Light switch in position for parking light (pos 1).

68-B-

B+

Lighting and signalling systems



69

BU/YE

Central locking motor passenger door front, operating current for unlocking

Out

Not operated

B+ -69

B+



Doors and locks









Activate function with diagnostics instrument.

69-B-

B+









B+ -69

<1V



70

BK

Power ground TWICE

In

Always

B+ -70

B+

TWICE











Operate central locking function

70-B-

<0.3V