Changing the rear bumper shell, Aero/Viggen

/ 9-3 (9400) / 2001 / 8. Body / Exterior / Adjustment/replacement / Changing the rear bumper shell, Aero/Viggen

Removing

1.	Remove the bumper, see . Place it on a surface where it will be well protected.

2.	Remove the upper cell block.

3.	Remove the bumper rail from the protective shell by removing it from the 14 retaining clips that secure it to the protective shell.

4.	Remove the cell block from the shell (wedged in the shell fastening lugs).

Fitting

1.	Press the cell section into the protective shell.

2.	Refit the rail in the protective shell. Note The rail should be positioned correctly by means of the locating stud.

3.	Fit the upper cell block.

4.	Refit the bumper, see

---

---

This project is supported by memberships and donations. If you use this site, please consider Joining SCNA and/or making a donation.