SAAB WIS ONLINE

Fifth bow latch motor

Fifth bow latch motor

Removing


1. Run the soft top so that the fifth bow and the soft top cover are completely raised.


2. Remove the covering shell.


3. Connect the diagnostics tool and operate the fifth bow latch motor to half open position (soft top cover access flap is half open) using the command:

“STC”

“Activate”

“5th bow latch motor ”

“Up”

4. Protect the rear panels and the boot lid. Fit the protection under the soft top cover, the motor can easily fall onto the boot lid.

5. Remove the operating arms from the fifth bow latch motor.


6. Unplug the connector.

7. Remove the bolts securing the motor and hold one hand under the motor when the last bolt is removed. Lift away the motor.


Fitting



1. Fit the latch motor and tighten the bolts. Respective collision cable end sleeves pointing at each other. Fit new cable ties.

Tightening torque, two upper bolts: 14 Nm (10.3 lbf ft)

Two lower bolts: 7 Nm (5.2 lbf ft)

2. Fit the operating arms to the motor.

3. Plug in the connector.

4. Run the soft top up and down a few times and check the function.

5. Refit the shell.


6. Adjust the lock function. See Adjusting fifth bow locking .

7. Connect the diagnostics tool and erase any diagnostic trouble code.

8. Remove the protection and run the soft top to closed position and lock it against the windscreen frame.