SAAB WIS ONLINE

Relay, hydraulic unit

Relay, hydraulic unit

Removing


1. Operate the soft top to its lowered position (open) to allow more light to enter.


Note

This task can be performed with the soft top raised (closed).


If the soft top cannot be operated, proceed as follows:

1.a. Release the rear seat backrest and fold it forward.

1.b. Remove the cover on the emergency opening valve and open the valve about one half turn (A) .

1.c. Unlatch the soft top from the windscreen frame.

1.d. Activate the fifth bow latch to UNLATCH using the diagnostic tool and raise the fifth bow.

1.e. Insert the wheel bolt tool through the opening in the right-hand luggage compartment trim and attach it in the drive mechanism link arm (B) .

1.f. Unlatch the soft top cover by pulling back on the tool until the soft top cover is lifted a few centimetres (C) .

1.g. Remove the tool, close the boot lid and open the soft top cover.

1.h. Carefully lower the soft top.

Warning

There is a pinch hazard and danger of crushing if you let go of the soft top in the half-open position (when vertical). It will fall backwards or forwards, depending on its centre of gravity.


1.i. Close the soft top cover.

2. Release the rear seat backrest and fold it forward.

3. Remove the cover on the hydraulic unit.


4. Fold back the luggage compartment mat and remove the bolts securing the hydraulic unit.

5. Lift up the hydraulic unit and unplug the connector.

6. Press out the locking pins in the plastic rivets and remove the relay holder.

Take care not to damage the hydraulic hoses

7. Remove the relay from the holder.


Fitting


1. Fit the relay. Make sure the relay is fitted as it was earlier.

2. Fit the relay holder to the hydraulic unit. Use new plastic rivets if necessary.

3. Plug in the connectors.


4. Fit the hydraulic unit to the torsion box.

Important

Check that the emergency operation valve is completely closed.


5. Replace the luggage compartment mat and refit the cover.

6. Connect the diagnostics tool and erase any diagnostic trouble codes. See Tech 2 menu structure .

7. Operate the soft top for 5 complete cycles. Checks its function and any DTCs.

8. Raise the rear seat backrest.