Wheel sensor, front left
Wheel sensor, front left |
1. |
Open the bonnet.
|
2. |
Detach the main fuse box and move it aside.
|
3. |
Separate the connector, press in its catch and remove it from the bracket.
|
4. |
Snip the cable tie on the suspension strut tower.
|
5. |
Unplug the level sensor's connector. Also detach the expansion tank and move it aside.
|
6. |
Raise the car and remove the wheel.
|
7. |
Clean the area round the wheel sensor using a soft wire brush.
|
8. |
Undo the wheel sensor retaining bolt and remove the wheel sensor.
|
9. |
Remove the grommet and withdraw the lead.
|
10. |
Detach the lead from the clips and lift out the sensor.
|
To fit |
1. |
Insert the lead and press the connector home.
|
2. |
Fit the wheel sensor in its holder and tighten the retaining bolt.
|
3. |
Smear the rubber grommet with a soap solution and fit it in lace.
|
4. |
Press the lead into the retaining clips.
|
5. |
Fit the wheel, see
Wheels.
. Lower the car.
Tightening torque: 110 Nm (81 lbf ft) |
6. |
Plug in the connector.
|
7. |
Fit a new cable tie to the suspension strut tower.
|
8. |
Plug in the level sensor's connector and refit the expansion tank.
|
9. |
Fit the main fuse box in place.
|