Auxiliary heater (LHD)
Auxiliary heater (LHD) |
To remove |
1. |
Disconnect the negative battery lead.
|
2. |
Undo the clamp securing the heater exhaust pipe to the auxiliary heater.
|
4. |
Place a receptacle under the engine. Fit a hose to the radiator drain nipple, open the nipple and drain the coolant.
|
5. |
Remove the heater exhaust pipe.
|
6. |
Lower the car.
|
7. |
Remove the expansion tank cap.
|
8. |
Remove the engine cover.
|
9. |
Unplug the fuel filter. Lift the filter out of its holder and place it to one side.
|
10. |
Unplug the heater connector.
|
11. |
Remove the hose to the wastegate diaphragm unit from the clip on the coolant hose.
|
12. |
Remove both coolant hoses from the connector to the cabin and disconnect them from the clip on the bulkhead.
|
13. |
Bend aside the coolant hose that is connected to the engine.
|
14. |
Remove the coolant hose that is connected between the heater and the cylinder head, from the cylinder head connection and from the clip on the fuel filter hose.
|
15. |
Remove the wastegate diaphragm unit and place it to one side.
|
16. |
Remove the heater from the mounting on the bulkhead.
|
17. |
Remove the fuel hose from the heater using
83 95 261 Fuel line tool
.
|
18. |
Remove the auxiliary heater.
|
To fit |
1. |
Fit the heater to the mounting on the bulkhead.
|
2. |
Connect the coolant hose to the cylinder head.
|
3. |
Connect the coolant hoses to the connector to the cabin and fit them to the clip on the bulkhead.
|
4. |
Fit the wastegate diaphragm unit and fit its hose to the clip on the coolant hose.
|
5. |
Plug in the heater connector.
|
6. |
Feed the heater's suction hose into the hole in the longitudinal member.
|
7. |
Fit the fuel filter and plug it in.
|
8. |
Raise the car.
|
9. |
Insert the heater exhaust pipe and fit it to the car floor.
|
10. |
Close the drain plug on the radiator and remove the hose.
|
11. |
Raise the spoiler shield, fit the bumper connector into the holder and plug in the connector.
Cars with headlamp washers: Fit the hose to the spoiler shield. All cars: Fit the spoiler shield. |
12. |
Lower the car.
|
13. |
Connect the exhaust pipe to the heater.
|
14. |
Fill the system will coolant and check for leaks. Fit the cap to the expansion tank.
|
15. |
Connect the negative battery cable.
|
16. |
Fit the engine cover.
|
17. |
Bleed the cooling system
.
|
18. |
Carry out
Procedures after reconnecting the battery
.
|
19. |
Cars with headlamp washers:
Check the function of the headlamp washers.
|
20. |
Check the coolant level and top up if necessary.
|