SAAB WIS ONLINE

Throttle body, removing and fitting

Throttle body, removing and fitting

To remove


1. Remove the engine protection cover.

2. Pull off the cable set connector (1) from the heat film mass airflow sensor. Remove the intake manifold together with the heat film mass airflow sensor - see Air filter housing, air control .


3. Pull off the throttle connection cable set connector (5).

4. Pull off the crankcase ventilation hose (1) and the tank vent valve line (2) from the throttle valve connection.

5. Remove the coolant hoses (3) from the throttle valve connection - collect the coolant.

6. Remove the retaining bolts (4) - remove the throttle valve connection from the intake manifold.


To fit


1. Fit the throttle valve connection together with a new seal onto the intake manifold - tightening torque 8 Nm.

2. Fit the coolant hoses to the throttle valve connection.

3. Fit the crankcase ventilation hose and the tank vent valve line on the throttle valve connection.

4. Fit the cable set connector onto the throttle valve connection.

5. Fit the air intake pipe - see Air filter housing, air control .

6. Fit the airflow sensor cable set connector.

7. Fit the engine cover.

8. Fill and bleed the cooling system - see Cooling system, filling and bleeding and Cooling system, leakage check .